coatings
Base Coat
Ceral 34 is a high temperature coating composition containing fine aluminum powder in a chromate/phosphate binder. Provides sacrificial corrosion and oxidation protection to temperatures up to 1100 degrees Fahrenheit. It preforms equal to or better than both Sermatel W and Sermatel 5380DP.
Top Coat Sealer
Ceral 50 is a phosphate-based seal coat that may be applied over Ceral 34 for the purpose of both improving corrosion resistance and extending the life of the coating. The seal coat also serves to improve surface finish by filling microscopic voids created by the dispersed aluminum particle distribution of the Ceral 34. It is resistant to hydraulic fluids, fuel and hot water, and highly resistant to thermal shock and impact damage.
Diffusion Aluminides
Diffusion aluminide coating is comprised of aluminum and silicon powder in an inorganic binder. The aluminide formed from diffusion into Cobalt or Nickel based alloys provides a very wear resistant and heat oxidation resistant surface.
IP 714 High Performance, Air Drying Chromate Free Primer
Heat Resistance: 400 degrees Fahrenheit hours for 48 hours without chalking, blistering or flaking.
Hot Oil Resistance: Film, after immersion for eight hours in ASTM Service Fluid No. 101 (ref. ASTM D 471) at 350 degrees Fahrenheit shall show no peeling, blistering or softening.
Fuel Resistance: Film shall withstand immersion in ASTM Reference Fuel ( ref. ASTM D 471) at room temperature for four hours without blistering, peeling or softening.
IP 715 High Performance, Air Epoxy Topcoat
Heat Resistance: 400 degrees Fahrenheit hours for 48 hours without chalking, blistering or flaking.
Hot Oil Resistance: Film, after immersion for eight hours in ASTM Service Fluid No. 101 (ref. ASTM D 471) at 350
degrees Fahrenheit shall show no peeling, blistering or softening.
Fuel Resistance: Film shall withstand immersion in ASTM Reference Fuel ( ref. ASTM D 471) at room temperature for four hours without blistering, peeling or softening.
